Bus Switches
UT54BS16210 20x1:1 Bus Switch
- Bus width
- 20 bits
- Channel bandwidth
- 500 MHz at -3 dB
- Case temperature
- -55°C to +125°C
Specifications
| Part Number | UT54BS16210 |
|---|---|
| Flight Grade | QML-Q, QML-V |
| Package | 48-lead FP |
| LET (MeV·cm²/mg) | ≤100 |
| TID krad(Si) | 100 |
| Supply Voltage | +3.3V to +5V |
| Impedance | 11Ω 5Ω |
Technical specifications
| Specification | Value | Notes |
|---|---|---|
| Bus width | 20 bits | |
| Supply and switch resistance | 3.3 V: 11 Ω typical | On-state connection resistance at the stated supply; typical, not a guaranteed maximum. |
| Supply and switch resistance | 5.0 V: 5 Ω typical | On-state connection resistance at the stated supply; typical, not a guaranteed maximum. |
| Channel bandwidth | 500 MHz at -3 dB | |
| Case temperature | -55°C to +125°C | |
| Total-dose capability | 300 krad(Si) | Radiation-assured ordering option; specify the applicable SMD RHA code. |
| Package options | 48-lead flatpack | Case and screening combinations depend on the orderable variant. |
Values are subject to the conditions and ordering options in the referenced product documentation.
Product overview
The UT54BS16210 is a 20-bit bidirectional bus switch for memory interfaces, bus isolation, and redundant signal paths. Its low on-state resistance connects the A and B ports with minimal propagation delay. The device is organized as two independently enabled 10-bit switches. Driving an output-enable input low connects the corresponding ports; driving it high opens the path and isolates the ports. Operation is supported from 3.3 V or 5 V supplies, with different typical on-state resistance at each voltage. The datasheet also identifies support for analog applications.
Documentation
Technical documents and resources
For product questions or additional technical information, contact Frontgrade https://www.frontgrade.com/contact-us-form.
Datasheet
IBIS Models
More about this product
Product features
- Bidirectional switch paths
- Output-enable control for bus isolation
- Support for analog switching
Controlled bus isolation
Its low on-state resistance connects the A and B ports with minimal propagation delay. The device is organized as two independently enabled 10-bit switches. Driving an output-enable input low connects the corresponding ports; driving it high opens the path and isolates the ports.
Applications
- Memory interfaces
- Bus isolation
- Redundancy
- Analog applications
Discuss your application
Contact Frontgrade to discuss UT54BS16210 20x1:1 Bus Switch and the requirements of your application.